AIR PURIFIER OPERATION MANUAL Free standing type FU-A80A Device of this mark is a trademark of Sharp Corporation. Plasmacluster is a registered trademark or a trademark of Sharp Corporation. OP_FU-A80A-EN+HK.indb 1 OP_FU-A80A-EN+HK.indb 1 9/21/11 2:42:54 PM 9/21/11 2:42:54 PM...
Page 2
Please read before operating your new Air Purifier Some odor ingredients absorbed by the filters may become separated and may be discharged through the air outlet and result in additional odor. Depending on the usage environment, especially when the product is used in a condition significantly more severe than household use, this odor may become strong in a shorter period than expected.
*From that air is drawn through the filter system. Applicable area : 62m Thank you for purchasing the SHARP Air Purifier. Please read this manual carefully. Before using this product, be sure to read the section: “Important Safety Instructions.”...
• Unplug the electrical cord before performing any maintenance. • If the power cord is damaged, it must be replaced by the manufacturer, its service agent, a Sharp authorized Service Centre or qualified person in order to avoid a hazard.
CAUTIONS CONCERNING OPERATION • Do not block the air inlet and air outlet. • Do not use the unit near or on hot objects, such as stoves or heaters or radiators. • Do not lay the unit down when using. •...
PART NAMES ILLUSTRATIVE DIAGRAM Air Outlet Air Inlet Handle BACK Main Unit HEPA Filter Active Carbon Deodorizing Filter Dust Sensor Date Label Power Cord Plug OP_FU-A80A-EN+HK.indb 4 OP_FU-A80A-EN+HK.indb 4 9/21/11 2:43:03 PM 9/21/11 2:43:03 PM...
CONTROL PANEL 11 12 16 17 18 SHOWER Button / SHOWER Indicator Light (green) Plasmacluster ON / OFF Button / Plasmacluster ON / OFF Indicator Light (green) CHILD LOCK Button / CHILD LOCK Indicator Light (green) CLEAN SIGN The colour changes according to the air condition. Green Yellow Clean...
FILTER INSTALLATION Unplug the electrical cord before installation. To maintain the quality of the filters, they are packed in plastic bags and installed in the main unit. Be sure to remove the filters from the plastic bags before operating the unit. Remove the front Panel.
OPERATION Press to start / stop. CLEAN SIGN Unless the power cord has been unplugged, the operation starts in the previous mode it The Dust sensor automatically monitors was operated in. indoor air quality.The CLEAN SIGN light will change accordingly. Press to select fan speed.
MAINTENANCE Care Cycle : Whenever dust accumulates on the unit or every 1 month. CLEANING THE FILTERS CLEANING THE UNIT Turn off the unit, and unplug the Wipe with a dry, soft cloth. power cord. For stubborn stains or dirt, use a soft cloth dampened with warm water.
FILTER REPLACEMENT GUIDELINES Filter life varies depending on the room environment, usage, and location of the unit. If dust or odor persists, replace the filter. Replacement Cycle • HEPA Filter About 2 years after opening • Active Carbon Filter About 2 years after opening Deodorizing HEPA filter Active Carbon Deodorizing Filter...
TROUBLESHOOTING Before calling for service, please review the Troubleshooting chart below, since the problem may not be a unit malfunctions. PROBLEM SOLUTION The unit leaves smoke and • Clean or replace the filters as needed. (Refer to E-9) odors in the air. •...
Need help?
Do you have a question about the FU-A80A and is the answer not in the manual?
Questions and answers