Sharp AN-WC11B Operation Manual page 24

Selecting the "Peer-to-Peer Channel"
When communicating in "Peer-to-Peer", you must specify a channel on which communications will
take place.
1
Select the channel you want to set from the box on the right of "Peer-to-Peer
Channel".
The channels that can be selected are displayed in a list.
2
Click "Apply".
The channel is changed to the channel you selected.
The "Peer-to-Peer Channel" is displayed in gray in "Access Point". The Access Point changes the
channel automatically; therefore it is not necessary to set the channel in the "Access Point".
I Setting the Transmit Rate
You can specify the speed data is sent by the Wireless LAN PC Card.
Setting the Transmit Rate
1
Click the pull down button on the right of the "Transmit Rate" box.
The transmit rates that can be selected are displayed in a list.
2
Select the transmit rate you want to set and click "Apply".
The speed is changed to the selected "Transmit Rate".
The transmit rate can be set to:
• Fully Automatic – your Wireless LAN PC Card chooses the highest available rate providing
• Auto 1 or 2 Mb – allows only 1 and 2 Mbps operation
• 5.5 Mb – allows only 5.5 Mbps operation
• 11 Mb – allows only 11Mbps operation
Normary, you should choose "Fully Automatic" as the transmit rate. Change the setting, only when a
problem occurs.
-24
reliable communications based on the capabilities of the Access Point or
Wireless LAN PC Card with communicates and on the received signal quality