Download Print this page

Speaker Connections - JVC KS-AX5801 Instructions Manual

Power amplifier

Advertisement

Available languages

Available languages

SPEAKER CONNECTIONS

Connection varies depending on the number of the speakers used in your car. Select the
appropriate connection referring to the following diagrams.
Before connecting: Securely connect all the parts. If the connections are loose, due to contact
resistance etc., heat will break out and may cause an accident. Secure and cover the cords with
insulating tape and run them under the car mats.
Subwoofer system
Note
Use the subwoofers with an impedance of 1 Ω to 8 Ω for KS-AX6801 or 2 Ω to 8 Ω for
KS-AX5801.
2-subwoofer system (2 amplifi ers)
Note
Incoming signals are emitted through the PRE OUT jacks.
Wired remote control unit: RM-RK130 (purchased separately)
Using JVC's wired remote control unit: RM-RK130 (purchased separately), you can adjust the
bass boost in your seat without adjusting the BASS BOOST controller on the amplifi er (see
"CONTROLS" on page 3) .
Note
Set the BASS BOOST controller on the amplifi er to MIN when you use RM-RK130.
A
Under the dashboard, etc.
Drilled hole
Screw (φ 4 × 12 mm)
(provided for RM-RK130)
Subwoofer
Subwoofer
Subwoofer
B
Remote Cord
(provided for RM-RK130)
RM-RK130
å When your receiver is equipped with Line Output, connect the Line Output (through the
receiver) to the INPUT jacks on this unit.
∫ When your receiver is NOT equipped with Line Output, connect the provided speaker
input connector (through the receiver) to the HIGH INPUT terminal on this unit.
2-subwoofer system
Subwoofer
Note
Use the subwoofers with an impedance of 2 Ω to 8 Ω for KS-AX6801 or 4 Ω to 8 Ω for
KS-AX5801.
4-speaker system plus subwoofer—5.1-channel (3 amplifi ers)
Line Out
Subwoofer Out
(Center)
JVC power amplifi er, etc.
(purchased separately)
Center Speaker
1
*
Not provided for this unit.
*
2
Be sure to connect the both leads to the target speaker lead.
3
*
Be sure to connect the line output from the receiver to the left (L) jack on this unit.
A Mount RM-RK130 on a fi rm surface, such as under the dashboard.
B Connect RM-RK130 to the REMOTE terminal on the amplifi er with the Remote Cord
provided for RM-RK130.
C The BASS BOOST controller boosts the 45 Hz frequency within the range of 0 dB to 18
dB. Adjust the level while listening to the sound.
• The POWER lamp lights in green while RM-RK130 is turned on.
2
Subwoofer
JVC power amplifi er, etc.
(purchased separately)
Subwoofer
C
POWER lamp
BASS BOOST
controller

Advertisement

loading

This manual is also suitable for:

Ks-ax6801