Advertisement
Available languages
Available languages
SPEAKER CONNECTIONS
Connection varies depending on the number of the speakers used in your car. Select the
appropriate connection referring to the following diagrams.
Subwoofer system (1 amplifier)
JVC car receiver, etc.
Line Out (Rear)
or
Subwoofer Out
Note
Use the subwoofer with an impedance of 1 Ω to 8 Ω.
2-subwoofer system (2 amplifiers)
JVC car receiver, etc.
Line Out (Rear)
or
Subwoofer Out
Note
• Use the subwoofers with an impedance of 1 Ω to 8 Ω.
• Incoming signals are emitted through the PRE OUT jacks.
Subwoofer system (2 amplifiers)—External Bridge Mode
Line Out (Rear)
JVC car receiver, etc.
Subwoofer Out
Amplifier A
Amplifier B
Note
• Use the subwoofer with an impedance of 2 Ω to 8 Ω.
• Use the subwoofer which have sufficient capacity to the unit.
• Make sure to set the EXTERNAL BRIDGE switch as illustrated above; otherwise, the sound
may be distorted.
• You cannot adjust the sound on the amplifiers separately. The adjustment on the amplifier A is
also applied to the amplifier B.
2
Subwoofer*
2
Subwoofer*
2
Subwoofer*
or
3
Subwoofer*
Before connecting: Securely connect all the parts. If the connections are loose, due to contact
resistance etc., heat will break out and may cause an accident. Secure and cover the cords with
insulating tape and run them under the car mats.
2-subwoofer system (1 amplifier)
JVC car receiver, etc.
Line Out (Rear)
or
Subwoofer Out
Note
Use the subwoofers with an impedance of 2 Ω to 8 Ω.
4-speaker system plus subwoofer—5.1-channel (3 amplifiers)
Line Out
(Front)
JVC car receiver, etc.
Line Out
(Center)
JVC amplifier, etc.
(purchased separately)
Note
Use the subwoofer with an impedance of 1 Ω to 8 Ω.
1
*
Not provided for this unit.
2
*
You can connect 2 subwoofers as shown in "Example 1" to "Example 4" below.
3
*
You can connect 2 subwoofers as shown in "Example 2" to "Example 4" below.
4
*
Be sure to connect the line output from the receiver to the left (L) jack on this unit.
Examples for connecting 2 subwoofers
Example 1
Load impedance: 1 Ω
Speaker Wire
Example 2
Load impedance: 2 Ω
2
3
Subwoofer*
JVC amplifier, etc.
(purchased separately)
Line Out
Front Speaker
(Rear)
(left/right)
Subwoofer
Out
Center Speaker
Example 3
Load impedance: 4 Ω
Subwoofer
(Dual 4 Ω)
Subwoofer
(Dual 4 Ω)
Example 4
Load impedance: 8 Ω
Subwoofer
(4 Ω)
Subwoofer
(4 Ω)
3
Subwoofer*
Rear Speaker
(left/right)
2
Subwoofer*
Subwoofer
(Dual 4 Ω)
Subwoofer
(Dual 4 Ω)
Subwoofer
(4 Ω)
Subwoofer
(4 Ω)
Advertisement
