Assembling The Subwoofer Stand - Epson Home Cinema System Installation Manual

Assembling the Subwoofer Stand

If you like, you can use the included stand to store the subwoofer and AV controller. It also provides space for
storing additional components.
other components here
Place subwoofer here
Follow these instructions to assemble the stand:
1 Unpack the stand from box #6.
2
Locate the base and set it flat on the floor or a worktable. You should see only the four holes for the rubber
feet (the six holes underneath the base should face downward).
Base
3 Use the nuts and bolts to connect the side panels to the base. Insert the nuts into the holes underneath the
base. Use a flathead screwdriver, if necessary, to align the nuts so the bolts thread into them. Make sure the
side panels face the correct direction (the side with more holes should face inward). Tighten the bolts with
the included Allen wrench.
Tip
You may find it easier to connect the side panels if you rest the stand on its back, instead of keeping it upright.
Place AV controller or
Side panels
49