Attach The Speaker Grilles To The Screen - Epson Home Cinema System Installation Manual

Note
The box also contains the wire management tracks and related pieces shown below. It is advisable to keep these
parts together until they're needed on page 43.
8-foot-long tracks
(6 pieces)
2
Unpack the speaker grilles from box #7. Note that two screws are packed with each grille. You will use
them to attach the grille to the screen, as described in the next section.

Attach the Speaker Grilles to the Screen

1 Remove and discard the plastic covers that protect the speakers during shipping.
2
Attach the speaker grilles. Hook each grille into the lip underneath the screen housing (where the screen
itself comes out). Then attach the grille on top with the two screws that came with it.
Caution
Be careful not to damage the grilles when handling them. Do not hold the screen by the grilles, which are fragile and
can be easily dented. Lift the screen only from the bottom and by holding the plastic covers on each end.
Wall-to-ceiling
transition (2 sets)
Corner connector
(3 sets)
Speaker grilles
and screws
20
Seam cover Drywall screws
(20 pieces) (100 pieces)