Epson Home Cinema System Installation Manual page 48

5 Locate the 16-foot (5-meter) AV data cable (packed in box #3). Connect it from the
the AV controller to the
Connect power cord to
outlet on subwoofer
6 Connect the AV controller's power cable to the remaining
can also connect it directly to a grounded power outlet in your home.
7 Connect the main power cord (packed with the subwoofer) to the power inlet on the back of the
subwoofer. Connect the other end to a grounded power outlet in your home.
Note
It is recommended that the Ensemble HD system be powered by a dedicated 20-amp circuit. Typical power
consumption is about 800 watts.
8 Set the
MASTER POWER
9
Set the
PWR ON MODE
signal.
10 Wrap any excess cable, secure it with cable ties (not included), and store it behind the subwoofer.
port on the subwoofer.
INPUT
BASS CONTOUR CONTROL
FREQ LEVEL
61 82
47 98
99
switch to the position.
ON
switch to the position. This lets the subwoofer turn on when it detects a
AUTO
PWR ON MODE
SUB OUT
MASTER
POWER
connector on the subwoofer. You
AC OUTPUT
48
port on
5.1CH OUT
Connect these ports with the
AV data cable