Epson Home Cinema System Installation Manual page 40

6 Turn the projector upside-down and slide it into the enclosure. Make sure the projector ports are on the
same side as the speaker cables, as shown. Attach the projector with the four screws and washers as shown.
7
Check the part of the ceiling mount where you will attach the
projector (the round plate on the bottom). Make sure the
three thumb screws are loosened enough so that they don't
protrude through the bottom of the round plate. If any of the
screws protrude, you won't be able to attach the projector.
Also, make sure the pointed part faces toward the screen. If
necessary, grasp the mounting bracket and rotate it so that it
faces the correct direction. (You may need to loosen the two
bolts at the top to rotate the assembly, shown in step 8.)
8
Securely tighten the two bolts at the top of the mounting
bracket. When they're tight, the round plate at the bottom of
the mount cannot be rotated.
Make sure thumb screws do not
protrude through bottom of plate
Point this part
40
toward the
screen
Tighten both bolts at the top