Adjust The Screen Position - Epson Home Cinema System Installation Manual

If you haven't already adjusted the projector settings, the image will be upside-down or you may see a
message. This is normal. You will adjust these settings in "Adjusting the Projector Settings" on page 56.
If the system doesn't turn on, check the following:
• If the system is not receiving power, make sure your electrical outlet is working and isn't controlled by
a wall switch or timer.
• Check that the power cords on the back of the subwoofer are connected securely.
• Check the
POWER
the position and the one near the top is set to
ON
• If the projector doesn't come on, make sure the power switch on the back of the projector is in the on
position. Make sure the lens cap is removed.
5
After the screen is lowered, remove and discard any protective packing material that was held in place with
the screen rolled up.

Adjust the Screen Position

The screen is factory-set to come down 55 inches, but you can set it to come down as far as 64 inches. It is
recommended that you set the screen to achieve a 7- to 10-degree viewing angle from your eyes, when you're
seated, to the center of the screen.
55 inches
1 Make sure the MAIN menu is displayed on the Ensemble HD remote control. If necessary, press the
button.
MAIN
2 Press the
PAGE
3
Press the button to the right of
switches on the back of the subwoofer. Make sure the one near the bottom is in
button to display the second page of components.
to select the projector menu.
PROJ
.
AUTO
64 inches
52
No Signal