Epson Home Cinema System Installation Manual page 30

2 With a second person's help, lift the screen onto the three mounting brackets. The screen must hook into
the groove on all three brackets. Tilt the screen back slightly when lowering it onto the brackets.
Warning
You must have a second person's help when lifting the screen. Use ladders as necessary to reach a high location.
Caution
Do not hold the screen by the speaker grilles, which are fragile and can be easily dented. Lift the screen only from
the bottom and by holding the plastic covers on each end.
3
Look from the sides to make sure the screen is properly hooked onto the mounting brackets. If the wall-
mounting brackets are used and the wall's surface is uneven, the screen might not have engaged with one or
more of the brackets.
4 If the screen is mounted on the ceiling, make sure the front of the casing doesn't tilt downward, or the
screen fabric will rub on the casing when it goes up or down.
5 If necessary, slide the screen a few inches left or right to position it correctly.
6
Insert the set screw in the bottom center of the screen. Use the included Allen wrench to tighten the set
screw and secure the screen onto the middle bracket.
Warning
Carefully check to make sure the screen cannot come off the brackets after you tighten the set screw. The set screw
is an important safety measure designed to prevent the screen from falling off in the event of an earthquake or other
disturbance. If the set screw does not align with the middle bracket, you must move either the screen or the bracket.
Insert set screw
30
Hook screen into groove
on brackets