List of ESC/VP21 Commands
Command List
When a power on command is sent to the projector, the power will turn on
and the projector will change to warm-up mode. When the power has
turned on, a colon ":" (3Ah) will be returned.
When the projector executes a command, it returns a ":" and waits for the
next command to be sent.
If command processing terminates with an error, the projector outputs an
error message and then returns the ":" code.
Item
ON
Power ON/OFF
OFF
Computer1 (Auto)
Computer1
Component Video1
Computer2 (Auto)
Signal selection
Computer2
Component Video2
Video
S-Video
ON
A/V Mute ON/OFF
OFF
Black
A/V Mute Selection
Blue
User's Logo
* When issuing any of the above commands, tack a Carriage Return (CR)
code (0Dh) on to the end.
Communication Protocol
Standard baud rate
• • • •
Data length
• • • •
Parity
• • • •
Stop bit
• • • •
Flow control
• • • •
Connector shape
• • • •
Command
Projector input port
• • • •
PWR ON
PWR OFF
SOURCE 1F
SOURCE 11
SOURCE 14
SOURCE 2F
SOURCE 21
SOURCE 24
SOURCE 41
SOURCE 42
MUTE ON
MUTE OFF
MSEL 00
MSEL 01
MSEL 02
: 9600 bps
: 8 bits
: None
: 1 bit
: None
: D-Sub 9-pin (male)
: Control (RS-232C)
96