Adjusting The Sync - Epson EMP EMP-81 User Manual

Adjusting the Image Quality

Adjusting the Sync

If flickering, fuzziness or interference appear in
computer or RGB video images, and this cannot
be fixed using automatic setup, you will need to
adjust the Sync (synchronisation)g
using the following procedure.
PROCEDURE
Press the [Menu] button on the remote control or the
1
projector's control panel, and then select "Sync." from
the "Signal" configuration menu.
For details on this operation, refer to "Using the Configuration
sp.66
Menus".
manually
Tilt the [ ] button on the remote control or press the
2
[ ] and [ ] buttons on the projector's control panel
to adjust the synchronisation value until the
flickering, fuzziness or interference disappears from
the images.
The sync value increases or decreases each time a button is
pressed.
After making the adjustment, press the [Menu] button
3
to exit the configuration menu.
TIP
• If you adjust the sync without adjusting the
be possible to get the best adjustment results. Incorrect tracking
adjustment may not be noticeable with some types of picture.
However, pictures with lots of lines and shading will tend to show
incorrect tracking adjustments more clearly, so be sure to check the
tracking adjustment first.
• Flickering and fuzziness may also occur when the brightness,
contrastg, sharpness and keystone correction settings are adjusted.
42
trackingg first, it will not