Using The Mail Notification Function To Report Problems; Setting Mail Notification Function; If A Problem Notification Is Sent By Mail - Epson EASYMP EMP-1705 Operation Manual

Using the Mail Notification Function to Report Problems

By setting the mail notification function from network settings in the
configuration menu, notification messages will be sent to preset e-mail
addresses when a problem or warning occurs with a projector. This
will enable the operator to be notified of problems with projectors even
at locations away from the projectors.
• Up to a maximum of three notification destinations
q
(addresses) can be recorded, and notification messages
can be sent to all three destinations at once.
• If a projector develops a critical problem and suddenly
stops working, it may not be able to send a message
notifying an operator of the problem.
• Setup and control with a Web browser are possible if set to
"Network ON" in the "Extended" menu of the projector's
configuration menu, even if the projector is in standby
mode (when the power is off).

Setting Mail Notification Function

Select "Mail" from network settings in the projector's configuration menu
and set the mail notification function.
(EMP-1715/1705 Only)" "Mail Menu"
Also, confirm the following points.
• Network settings have been made to allow the projector and computer to
connect via a wireless LAN in the "Advanced Connection Mode" or the
wired LAN unit.
sUser's Guide "Network Menu (EMP-1715/1705 Only)" "Mail Menu"

If a Problem Notification is Sent by Mail

When the mail notification function is set to "On" and the projector enters
an abnormal/warning state, the following mail is sent.
sUser's Guide "Network Menu
Subject: EPSON Projector
First line: The projector name of the projector where the abnormality
occurs
Second line: The IP address set for the projector where the abnormality
occurs
Third line and on: Details of the abnormality
The details of the abnormality are described one by one, one line at a time.
The following table explains the details shown in the message.
For details on dealing with abnormalities/warnings, see
"Reading the Indicators".
Item
Internal error An internal error has occurred.
Fan related error A fan error has occurred.
Sensor error A sensor error has occurred.
Lamp timer failure Lamp failure has occurred.
Lamp out A lamp error has occurred.
Lamp cover is open. The lamp cover is open.
Internal temperature A high temperature error has occurred. (Overheating)
error
High-speed cooling A high temperature warning has occurred.
in progress
Lamp replacement It is time to replace the lamp.
notification
No-signal No Signal
No image signal is being input to the projector. Check
the connection status for the projector and that the power
supply for the connected equipment is turned on.
The (+) or (-) at the beginning of the sentence
(+): An error has occurred in the projector
(-): An error in the projector has been dealt with
39
sUser's Guide
Details shown