Epson EASYMP EMP-1705 Operation Manual page 84

Troubleshooting
Check
Is power being supplied to the projector?
Is the network cable connected correctly?
For Wired LAN
Cannot control or monitor the projector with EMP Monitor
f
Check
Is the wireless LAN unit connected?
For Wireless LAN
Is the network connect setting correct?
Is EMP Monitor correctly installed in the computer?
Are all of the projectors that you want to monitor and
control registered to the projector list?
Is "Standby Mode" set to "Network On"?
Is power being supplied to the projector?
Is the network cable connected correctly?
For Wired LAN
f Error message when starting up EMP Monitor
Check
The password is incorrect.
Cannot connect to the projector for the IP address
that was entered.
Check that your electrical outlet or power source is functioning correctly.
Check that the network cable is connected correctly. Reconnect it if it is not connected or not connected
properly.
Check that the wireless LAN unit is securely connected.
Check the projector's network settings. s
Uninstall and then reinstall EMP Monitor.
Register them to the projector list. sEMP Monitor Operation Guide "Registering and deleting projectors for
monitoring"
To use the mail notification function when the projector is in standby, set "Network On" in "Standby Mode"
from the configuration menu. s User's Guide "Extended Menu"
Check that your electrical outlet or power source is functioning correctly.
Check that the network cable is connected correctly. Reconnect it if it is not connected or not connected
properly.
The wrong password was entered. Enter the correct password. If you forget the password, start "Network
Settings" in "Network" from the configuration menu, and check "Web Control Password" in "Basic Settings".
Check whether the network settings for the projector you want to connect to, the wired LAN or "Advanced
Connection Mode (wireless LAN)" are the settings that are used.When "Quick Connection Mode" is selected
from "Wireless LAN", the setting is changed to "Advanced Connection Mode".
Next, check the "IP Address" for the "Wired LAN" or the "Wireless LAN" and register the "IP Address"
manually. s EMP Monitor Operation Guide "Registering and deleting projectors for monitoring"
If it still does not connect, check the network settings on the computer and the network settings for the
projector.
For network settings, s Wireless LAN Quick Connection Guide
Remedy
Remedy
User's Guide "Network Menu (EMP-1715/1705 Only)"
Remedy
84