Jumper Settings - Zotac GeForce 8100 User Manual

GeForce 8100/8200/8300 series Motherboard
When installing a PCI Express x16 card, be sure the retention clip snaps and locks
the card into place. If the card is not seated properly, it could cause a short across the
pins. Secure the card's metal bracket to the chassis back panel with the screw used
to hold the blank cover.
Jumper Setting
This chapter explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this
chapter whenever in doubt.
JH-CMOS Clear
JH
1-2*
2-3
JP-PS Power Selection
JP
1-2
2-3*
Close Open * Default setting.
If you want to clear the system configuration, use the J1H1 (Clear CMOS Jumper) to
clear data.
Notice:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be
seen even if the frequency multiplier setting in CMOS setup is changed.

Selection
Normal*
CMOS Clear
Selection
5V power input
5V standby power input*