Ide Configuration; Superio Configuration; Hardware Health Configuration; Acpi Configuration - Zotac G45-ITX series User Manual

IDE Configuration

The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Press <enter>to display the configuration options:
q SATA#1/2 IDE Configuration
The items allow you to configure SATA#1/2.
q Configure SATA#1 as
This item allows you to set the SATA#1 to IDE/RAID/AHCI mode.
q Primary, Secondary, Third and Fourth IDE Master/Slave
This displays the status of auto detection of IDE devices.
q Hard Disk Write Protect
This item will be effective only if device is accessed through BIOS.
q IDE Detect Time Out (Sec)
The item allows you to select the time out value for detecting ATA/ATAPI devices.
q ATA(PI) 80pin cable detection
The item allows you to select the mechanism for detecting 80pin ATA(PI) cable.

SuperIO Configuration

The items in this menu allow you to configure F71862 Super IO Chipset.

Hardware Health Configuration

This menu gives you an overview of the Hardware Health Configuration.

ACPI Configuration

The items in this menu allow you to set General ACPI Configuration, Advanced ACPI
Configuration and Chipset ACPI Configuration.
AHCI Configuration
The items in this menu allow you to set general AHCI configuration.
ASF Configuration
The items in this menu allow you to set Alert Standard Format Support.
Intel AT-d Configuration
The menu allows you to enable or disable Intel AT-d technology.
Intel TXT(LT) Configuration
The menu allows you to configure Intel TXT(LT) Parameters.

MPS Configuration

The item in this menu allows you to select MPS revision. The default setting is 1.1.

PCI Express Configuration

The item in this menu allows you to enable or disable PCI Express L0s and L1 link
power states.

Smbios Configuration

The item in this menu allows you to enable or disable Smbios Smi Support.
Configuring the BIOS
21