Ide Configuration; Hardware Health Configuration; Acpi Configuration; Ahci Configuration - Zotac H55-ITX wifi series User Manual

q Intel(R) HT Technology
This item allows you to enable or disable Intel ® Hyper-Threading technology
support .
q Active Processor Cores
This item allows you to choose the number of the active processor cores. The
default value is [All].
q A20M
This item allows you to enable or disable A20M.
q Intel(R) SpeedStep(tm) tech
Use this option to enable or disable Intel ® SpeedStep
q Intel(R) C-STATE tech
Use this option to enable or disable Intel ® C-STATE Technology.
q C3/C6 State/C State package limit setting/C1/C3 Auto Demotion
Use these options to control the C state settings.

IDE Configuration

The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Press <enter>to display the configuration options:
q Configure SATA as
This item allows you to set the SATA to IDE/RAID/AHCI mode.
q SATA#1/2 IDE Configuration
The items allow you to configure SATA#1/2.
q Primary, Second, Third and Fourth IDE Master/Slave
This displays the status of auto detection of IDE devices.
q Hard Disk Write Protect
This item will be effective only if device is accessed through BIOS.
q IDE Detect Time Out (Sec)
The item allows you to select the time out value for detecting ATA/ATAPI devices.
q ATA(PI) 80pin cable detection
The item allows you to select the mechanism for detecting 80pin ATA(PI) cable.

Hardware Health Configuration

This menu gives you an overview of the Hardware Health Configuration.

ACPI Configuration

The items in this menu allow you to set General ACPI Configuration, Advanced ACPI
Configuration and South Bridge ACPI Configuration.

AHCI Configuration

The items in this menu allow you to set general AHCI configuration.

Intel TXT(LT) Configuration

The menu allows you to configure Intel TXT(LT) Parameters.

Intel VT-d Configuration

The menu allows you to enable or disable Intel VT-d technology.

MPS Configuration

The item in this menu allows you to select MPS revision. The default setting is 1.4.
Configuring the BIOS
Technology.
TM
21