Hopperassembty Instructions - Craftsman 486.24211 Owner's Manual

ASSEMBLY OF HOPPER BAG
Insert the left hand upper hopper tube through the
stitched flaps of the hopper bag, starting at the center
cut out in the top ofthe bag. See figures 8, 9 and 10,
Repeat for the right hand upper hopper tube.
CENTER CUT OUT
(START HERE)
UPPER HOPPER TUBE
(LEFT HAND SHOWN)
BAG FLAP
/
/
• Assemble the two lower hopper tubes together using a
1/4" x 1" curved head bolt and a 1/4" hex lock nut. See
figure 11.
1/4" X 1"
CURVED HEAD BOLT
.
\
FIGURE 11
FIGURE 8
END HERE
Slide the two upper hopper tubes together and line up
the center holes as shown in figure 9.
UPPER HOPPERTUBES
FIGURE 9
• Fasten the upper hopper tubes together using a 1/4" x 1"
curved head boltand a 1/4" hex lock nut. See figure 10,
1/4" x 1" CURVED HEAD BOLT
Place the assembled lower hopper tubes into the
bottomof the hopper bag as shown in figure 12.
Assemble the ends of the upper and lower hopper
tubes together using two 3/8" x 3/4" hex boils (on _e
inside) and two 3/8" hex lock nuts (on the outside).
Tighten to allow bag to pivot freely. See figure 12.
UPPER
HOPPER
TUBE
=3/8"HEXLOCK NUT
LOWER HOPPERTUBE
3/8" x 3/4" HID( BOLT
(INSIDE)
FIGURE 10._ FIGURE 12
HOPPER BAG
BOTTOM