Choosing When To Display The Image - Epson PowerLite 600p User Manual

User's Logo Capture
Set the zoom rate.
zoom rate :
100 200 300
:Return :Select :Execute
note
You can also set up your
image as the startup screen
using the Advanced menu; see
page 55.
Fine-tuning the Projector
52
4. Use the
Tracking
button (remote control) to select the area of the image you want
to use. Then press
5. When you see the message "Do you use this image?" select
and press .
You see the screen shown at the left.
6. Use the
Tracking
the button (remote control) to select a zoom rate (display
size), and then press
7. When the message "Do you save the user's logo?" appears, select
and press .
Yes
Saving the logo may take a few moments. Do not use your
projector or video source (computer, DVD player, etc.) while the
logo is being saved.
8. When you see the message "Saving the user's logo is completed,"
press to return to the menu screen.
Esc

Choosing When to Display the Image

After your image is saved, you can set it up as the no-signal message
and/or the screen that's displayed when you press
1. Press the button to display the menu screen (if not already
Menu
displayed).
2. Use the
Sync–
(remote control) to highlight the
3. Press the button to select the Setting menu.
4. Use the
Sync–
(remote control) to highlight either
, depending on when you want the image to display.
Mute
5. Use the
Tracking+
(remote control) to select
to be displayed.
6. When you're finished, press
and buttons (control panel) or the
Sync
.
and buttons (control panel) or
Sync
.
button (control panel) or the
Setting
button (control panel) or the
No-Signal Msg
button (control panel) or the
. This sets your image as the screen
Logo
or
Esc Menu
Yes
.
A/V Mute
button
menu.
button
. or
A/V
button
to exit.