Table of Contents
Advertisement
Cleaning and Replacing the Air Filter
Clean the air filter on the bottom of the projector after every 100 hours of use. If it's not
cleaned periodically, it can become clogged with dust, preventing proper ventilation. This can
cause overheating and damage the projector.
1. Turn off the projector and wait for the P power light to stop flashing.
2. Unplug the power cord and disconnect any cables.
3. Turn the projector over. Then use a small vacuum
cleaner designed for computers and other office
equipment to clean the filter, as shown. If you don't have
one, gently clean the filter using a very soft brush (such
as an artist's camel-hair brush).
If the dirt is difficult to remove or the filter is broken,
replace it. Contact your dealer or call Epson at (800)
873-7766 and ask for part number
Canada, call (800) 463-7766 for dealer referral.
4. If you need to replace the filter, press the tab in and lift the
cover up.
5. Remove the old filter and replace it with a new one.
6. To replace the cover, insert the tabs and press down until the
cover clicks into place.
. In
V13H134A04
27
Advertisement
Table of Contents
