EPSON PowerLite Quick Setup Unpack the projector Your projector comes with the following items: Remote control Set up the remote control Pull out the insulating tape to remove it from the battery holder. The remote control is ready for use.
Connect your equipment The projector has 4 types of connections, as shown below. Each one is color-coded and requires a different type of cable (not included). You can connect up to 4 video sources and use the remote control to switch from one to the other.
Choosing a location The easiest way to set up your projector is to place it on a table in front of your screen or wall, or on a high shelf behind you. See the User’s Guide for other ways of setting up the projector.
Power light Turn on your equipment. (If you are connecting to a computer, don’t turn it on yet. Wait until you’ve turned on the projector.) Press the You hear a beep, the projector lamp comes on in about 45 seconds.
Where to get help Telephone Support Services ® To use the EPSON enter the PIN on the included EPSON PrivateLine Support card. This service is available 6 to 6 duration of your warranty period. You may also speak with a projector support specialist by dialing one of these numbers: U.S.:...
Remove the clear film covering the infrared receivers. EPSON is a registered trademark of SEIKO EPSON CORPORATION. PowerLite and PrivateLine are registered trademarks and EPSON Store is a service mark of Epson America, Inc. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners.