Table of Contents
Advertisement
Only part of the picture is displayed, or the picture is distorted.
■
Press the
Aspect
■
Use the
Position
page 22 for details.
The picture is trapezoid-shaped.
Press the
and
The picture contains static or noise.
■
Make sure your cable is securely connected at both ends.
■
Don't use an extension cable or a cable longer than 6 feet.
■
If you're displaying the same image on your computer and projector screen, try turning
off your laptop's LCD display.
The picture is blurry.
■
There may be dirt on the lens. Clean the lens as described on page 25.
■
Adjust the focus using the focus ring.
■
Make sure the lens is not fogged by condensation. If you've just moved the projector from
a cold environment, wait a couple of minutes before using it.
■
Adjust the
Sharpness
from a computer, you may also need to adjust the
You see vertical stripes, or the picture still looks blurry after trying the solutions in the
previous section.
If you're projecting from a computer, press the
optimizes the projector's tracking and sync settings. If this doesn't work, change the
and
settings in the projector's Image menu.
Sync
The colors on the screen don't look right.
■
Press the
Color Mode
mode settings.
■
Adjust the following settings in the Image menu:
(video only),
Tint
■
If the picture looks darker, you may need to replace the lamp.
button to select a different aspect ratio.
setting in the Setting menu to reposition the image on the screen. See
buttons on the projector to correct the problem.
setting on the Image menu (see page 19). If you're projecting
button on the remote control to move through the different color
(video only),
Color Temperature
and
Tracking
button on the remote control. This
Auto
,
Brightness
Contrast
, and
Flesh Tone
settings.
Sync
Tracking
,
Saturation
. See page 19.
35
Advertisement
Table of Contents
