Using The Projector; Choosing A Location - Epson POWERLITE HOME 10+ CPD-1790-4R2 User Manual

Using the Projector

Follow the instructions in this section to choose a location for the projector, adjust the image
and volume, turn off picture and sound, freeze the action, or use the projector menus.

Choosing a Location

The distance from the projector to the screen or wall determines the size of the picture. The
picture will be larger when you place the projector further from the screen. See the Quick
Setup sheet for details about the relationship between distance and picture size.
You can also choose from five different viewing setups. If you install the projector in a rear or
overhead position, you'll need to choose the correct Projection option (identified below) from
the projector's Setting menu.
■
Table: For temporary front projection, place the projector on a
low table in front of the screen. If possible, place the projector
directly in front of the screen, facing the screen squarely. The
base of the lens should be about level with the bottom of the
screen.
■
Shelf: You can also place the projector on a high shelf behind
you. Attach the three rubber feet that came with the projector
to the top of the projector, then place the projector
upside-down. After you turn on the projector, choose
for the Projection option in the Setting menu.
Front/Ceiling
■
Ceiling: You can purchase special equipment from Epson to
attach the projector to your ceiling (see page 12 for ordering
information). If you choose this setup, professional installation
is recommended. Choose
option.
for the Projection
Front/Ceiling
Table
Shelf
Ceiling
13