Registering An Id Number For A Remote Control - Epson EMP-7950 User Manual

Functions for Enhancing Projection
Use the [ ] button on the remote control or the [ ] or
2
[ ] button on the projector's control panel to select
the desired ID number (1–9).
Press the [Enter] button on the remote control or the [Auto/
Enter] button on the projector's control panel to accept the ID
number setting.
Video
Brightness Control
Audio
Projector ID
Effect Network
Setting
COM Port
User's Logo
Auto Setup
Advanced1
BNC Sync Termination
Advanced2
Direct Power ON
About Operation Lock
Reset All
Reset
[ ESC ]: Return [ / ]: Select
Once the setting has been made, press the [Menu]
3
button to close the configuration menu.
When the ID number is registered, the projector cannot be
operated by remote control unless the remote control used has
the same ID number or has an ID number of "0".
:
High Low
: 6
Set
Set
:
RS-232C USB
:
ON OFF
:
ON OFF
:
ON OFF
:
ON OFF
Execute
[Menu]: Exit
[ ]: Set

Registering an ID Number for a Remote Control

PROCEDURE
Press the [ID] button on the remote control.
1
The [ID] button will light.
Remote control
Press the [0] to [9] buttons on the remote control to
2
specify the ID number for the remote control.
The light for the [ID] button will turn off and the registration
will be complete. If a number other than "0" is registered, the
remote control will only be able to operate projectors that have
the same ID number.
Remote control
User's Guide
75