Epson EMP-7950 User Manual page 111

Centralised Control using EMP Monitor
Once all new projectors to be monitored have been
6
added, click [Close].
The display will return to the Register projector window, and
the names of the added projectors will appear in the projector
list.
: Projectors registered using the Manual registration function
: Projectors registered using the Auto detect function
Once all target projectors have been registered, click
7
[Close].
If there are any projectors in the list that you do not need to
monitor, select the Projector name and then click [Delete].
TIP
If the IP addressesg for projectors that have been registered using the
Manual registration function have changed, you can select the
Projector name and then click [Edit] to change the IP address. [Edit]
cannot be used for projectors that have been registered using the Auto
detect function.
The statuses of the registered projectors will each be
8
displayed.
Once a projector has been registered, the status of the projector
will be displayed automatically each time EMP Monitor is
started from then on.
The following table shows the display details.
The projector statuses are indicated by means of the following
Status :
icons.
Power ON with no problems
Power OFF with no problems
Power ON with a problem
Power OFF with a problem
Network error (not connected to network, power cable is
not connected, etc.)
Name : Shows the name of the projector.
User's Guide
110