Blade Carriage To Radial Arm Assembly - Craftsman 113.234701 Owner's Manual

Assembly
Blade Carriage to Radial Arm
Assembly
Note: It may be easier to do this assembly
with the parts still in the box because they
are connected by a cord; otherwise you
may need help to lift both parts out of the
box at the same time.
1. Set out:
-radial arm
-blade carriage.
Do Not Remove
These Screws
Carriage
Bearings
Stop
Screw
Front Trim
Radial Arm
Blade Carriage
2. Look inside arm towards switch hous-
ing to locate two screws that hold front
trim to switch housing. Remove these
two screws and front trim.
WARNING-
Do not remove screws on top of
radia! arm. Removal of these
screws affects integrity of switch
assembly and can create an electri-
cal hazard.
3. Use a No. 3 Phillips screwdriver to
remove front carriage stop screw and
bumper from end of arm.
4. Use v2"wrench to loosen carriage
stop screw on top of radial arm about
a/4"(enough to let blade carriage clear
when inserted).
/F_ont Trim
20: )..
St°BPuS:;eer_ / _
Radial A_rm
Screws
Switch
Housing
16