Table of Contents
Advertisement
Blade Guard Assembly
..........
' ......
1. Frorn amongthe loose parts, locate the folk_wirlg hardware:
Hex Screw -
114-20 x 1/2" (2)
©
1/4" External
Lockwasher (4)
Carriage Bolt - 1/4-20 x 7/8" (1)
Q
Flat Washer (1)
Wing Nut 114-20 (1)
Hex Screw - 1/4-20 x 2-1/8" (1)
G
Spreader Support/1)
Spreader Bracket (1)
2. Position
large
recessed
shoulder
end of
the
spreader support against end of pivot rod and fas-
ten to table using the 1/4-20x2-1/8"
long hex screw
and 1/4" external tooth Iockwasher.
Recessed /
/.'f
/
/ 2
8ackof
"'Pivot Rod
_ _asher
1/4"
Screw ,,
1/4-20 x 2-1/8
3_ Position the spreader bracket to the spreader sup-
port as shown
The 1/4-20xl/2"
screws and lock-
washers are to be assembled finger' tight only at this
time.
4_ Insert the 1/4-20 x 7/8" carriage bolt in the square
feature of the spreader bracket as shown. Assemble
the fiat washer first, then the 1/4 external Iockwasher
and the 1/4-20 wing nut on the carriage bolt leaving
the wing nut loose at this time.
5, Attach bIade guard and spreader by positioning the
open slot in the spreader directly above the spreader'
brackeL
Slide
the
spreader
down
between
the
spreader bracket and the head of the rivet until either
the open slot sets on the rivet or the spreader sets
on the table top sudace. Tighten wing nut.
NOTE: Both wash'ers must be positioned between the
spreader' and the wing nut,,
Spreader
Win
Nut
Carriage Belt
1/2-20x7/8
10
Hide quick links:
Advertisement
Table of Contents
