Epson USN 52R Operating Manual page 194

Storing a new probe
– Enter a probe name as follows:
– Simultaneously press N and O allocated to the
function P-NAME.
You will see the following display:
The cursor flashes at the entry position.
In the two lower lines you will see letters, numbers and
characters which you can use for the data set name.
To enter the required text, start by selecting the entry
position in each case, and then select the character
which should be inserted at this position.
The entry position and character are always marked by
a flashing cursor. You can enter all required characters
in any chosen order.
Krautkramer USN 52R/USN 52L Option DGS
– Press the keys T or V in order to change the entry
position.
– Press the keys N or O next to the corresponding
character string in order to select a character. The
flashing cursor changes the string automatically. The
highlighted character is immediately inserted at the
entry position.
– Finally, press the key X to store the entries.
H Note:
The probe name is stored together with the data set.
You can use the same probe name for more than one
data set if the probe parameters differ. However, we
strongly recommend you to use different probe names
for different probes.
Issue 02, 03/99
Operating the DGS
DGS-19