Epson USN 52R Operating Manual page 120

Printing instrument settings and display contents
H Note:
In cases of doubt, refer to the technical specifications
of the connected device. This is the only way to ensure
error-free communication.
In the function COPY MODE of the same function
group you select which data are to be printed:
• HARD COPY: Printout of the display contents
• REPORT: Printout of the Data Logger contents
• THICKNESS: Transfers the thickness value. When
angle function is enabled, the values for S=, P= and
D= are transferred.
• DATA LOGGER: The Data Logger is enabled for
storage of the measured values. When A is pressed,
a measured value is transferred to the Data Logger.
• DISP+PDUMP: Prints the A-scan and a single-page
test report with all settings relevant to the test.
• PARAMETER DUMP: Prints a list of all USN 52 R
functions including remode codes and actual
settings.
• MEMO DUMP: Prints the additonal information
added with the active MEMO function.
Krautkramer USN 52R/USN 52L
You can also select the printer:
Press N and O simultaneously in the function
COPY MODE.
The function PRINTER SELECT appears. You can
select the following printers:
• EPSON FX (also for EPSON LX-300)
• SEIKO DPU 411 (also for Seiko DPU 414)
– Select the required printer with M.
– Simultaneously press N and O again in order to exit
the function PRINTER SELECT.
You are now in the COPY MODE again.
– By activation of A you can transfer the data to a
printer or to the Data Logger.
Issue 05, 02/00
Documentation
6-3