Recommended Accessories - Craftsman 113.198111 Operator's Manual

*Recommended Accessories
Item Cat. No.
Saw blades
(10" diameter with 5/8" hole) See Catalog
Leg Set Caster 9-22221 or 9-22222
Sanding [)rum
Drill Chuck and Key
Dust Collector
Molding Head Guard 8"
Taper Jig
Auxiliar 5' Table Cover
Miter Square
Pin Router
Extension Table
Satin Cut Dado
7r'
8"
8" Carbide
Standard Cut Dado
8"
Adjustable Dado
7"-24 Tooth Carbide
7"-32 Tooth Carbide
7"- 16 Tooth Carbide
8"-48 Tooth Carbide
Molding Heads
7"-Bits Not Included
7"-27 Piece Set
7"-15 Piece Set
Sanding Wheel- l 0"
Blade Stabilizer
Cabinet Accessories
Shelf
Door
3 Drawer Set
Books
Power Tool Know How
Handbook
Guards
Lower Retractable Guard
(For 90 ° Crosscut Only)
9-25246
9-2980
See Catalog
9-29523
9-3233
See Catalog
9-32056
9-32765
9-32787
9-3257
9-3253
9-3264
9-32475
9-3261
9-3262
9-3263
9-32708
9-3214
9-3217
9-3218
9-22723
9-2952
9-22251
9-22252
9-22253
See Catalog
9-29009
* Recommended means that these accessories
are designed to fit this radial arm saw. Read
and follow accessory instructions on their use
and limitations.
Lower Retractable Guard
A lower retractable guard which meets
OStIA requirements for occupational use
of the radial saw is available. (See Note)
The lower guard is designed to provide
protection from contact with the flat sides
of the blade when the radial saw is in the
90 ° crosscut position and in its rearmost
position behind the fence. The lower
guard only provides protection against
minor lacerations and bruises.
A_,WARNING: The lower guard does
not provide protection during actual
crosscutting or ripping, or from con-
tact in line with or at an angle to the
saw blade teeth. When in the cut, the
inner and outer guards ride on top of
the fence or workpiece exposing the
saw blade teeth. Fingers, hands or
arm can be cut off if the saw blade is
contacted. Additional hazards are ex-
plained in the instructions accompan-
ing the lower blade guard.
_lb WARNING: The lower blade
guard can get caught or jammed in
fence and table kerfs, jam while set-
ting up for and while making bevel
and compound miter cuts and jam
during certain in-rip cuts. The
workpiece or narrow cut-off pieces
could kickback causing your hands
to be cut by the blade. Use the
lower retractable guard in the 90 °
crosscut position only.
• -'q
WARNING:
TO AVOID INJURY
SHUT OFF POWER
BEFORE CLEARING A
JAMMED LOWER GUARD
Fig. 118 Lower Guard Label
NOTE: Employers are required to provide the
lower retractable guard unless OS HA grants
an exemption. This saw is designed for use in
non-commercial settings.
56