Recommended Accessories And Tools; Carton Contents; Table Of Loose Parts; Tools Needed - Craftsman 137.248840 Operator's Manual

RECOMMENDED ACCESSORIES
IA WARNING I
Visit your Scars Hardware Department or see the
Scars Power and Hand TooJ Catalog to purchase
recommended accessories for this power tool
IA WARNING n
To avoid the risk of personal injury, do not
modify this power tool or use accessories not
recommended by Sears.
To avoid the risk of personal injury:
o Do not use adjustable (wobble) type dadoes or
carbide tipped dado blades; maximum dado width is
1/2 in.
® Do not use a dado with a diameter larger than 6 in.
o Do not use molding head set with this saw.
® Do not modify this power tool or use accessories not
recommended by Sears.
TOOLS NEEDED
Adjustable Wrench
Fiat Blade Screwdriver
Phflips Screwdriver
I Illllllllll ]
Steel Ruler
Combination Square
Separate all parts from packing materials. Check each
part with the illustration on the next page and the "Table
of Loose Parts" to make certain all items are accounted
for, before discarding any packing material
[_ WARNING 1
ff any part is missing or damaged, do not attempt
to assemble the table saw, plug in the power cord,
or turn the switch ON until the missing or damaged
part is obtained and is installed correctly.
TABLE OF LOOSE PARTS
ITEM DESCRIPTION QUANTITY
A Table Saw Assembly 1
B Table Extension 2
C Rear Table Extension 1
D Rear Table Extension Tube 2
E Location Seat 5
F Blade Guard and Splitter 1
G Guard Mounting Bolt, Fiat Washer, 1 each
Toothed Washer, Oval Washer,
Spring Washer
H Rip Fence 1
I Hand Wheel 2
J Dome Nut 2
K Dado Table insert 1
L Miter Gauge 1
M Hex Key 1
N Blade Wrench 2
O Blade 1
P Dust Chute 1
Q Dust Bag 1
STAND
R
S
T
U
V
W
X
Short Upper Support 2
Long Upper Support 2
Short Bottom Support Bracket 2
Long Bottom Support Bracket 2
Leg 4
Stand Mounting Hardware 1
Fence Storage Hardware Bag 1
and Extension Table Leveling
Spacers
NOTE: To make assembly easier, keep contents of box
together. Apply a coat of automobile wax to the table.
Wipe ali parts thoroughly with a clean dry cloth. This
will reduce friction when pushing the workiece. To avoid
injury, the styrofoam block should be removed between
the motor and the table.