Mounting The Front Table - Craftsman 113.198111 Operator's Manual

Mounting the Front Table
1. Make sure that the front table is upside
down.
2. Place a tee nut over the leveling hole and
hammer it into place. (Figure 41)
Tee Nut --.--_/_..
[
Leveling Ho,e_ .F_ -
Fig. 41
Bolt
Head Screw
Loc
Hex Nut Mounting Holes
:rew
g Hole
Fig. 45
Fig. 42 - Nut Tee
3. Slide a U-clip onto the center channel of
the saw as shown. (Figure 43)
Fig. 4 a
Fig. 44 - u Clip
5. Start the cup point set screw through the
leveling hole. Do not tighten. (Figures 45 &
46)
Fig. 46 - Cup Point Set Screw
6. Put a washer in each of the mounting
holes, (Figures 45 &47)
G
Fig. 47 - Washer for Mounting Holes
7. Start a pan head machine screw through
the center mounting hole. Do not tighten.
(Figures 45 &48
4. Place the front table on the saw so that the
mounting holes in the table line up with holes
in the table supports and center channel o[
saw, (Figure 45)
Fig. 48 - Pan Head Machine Screw
20