Advertisement
OPERATION
HOW TO STOP THE EDGER
1. Move the clutch lever backto the DIS-
ENGAGED position. T hen, move the
throttle control to the STOP position.
See Figure7.
A
WARNING: Never leave the
EDGER unattended while the
engine Is running. Always die-
engage the cutting blade and stop the
engine.
HOW TO USE
THE THRO'I'I'LE CONTROL
1.
Dudng normal use, run the engine at full
speed.
2.
Move the throttle control up to increase
engine speed, or down to decrease en-
gine speed (see Rgure 7).
HOW TO USE
THE PRIMER BUTTON
When startinga coldengine, pushthe prim-
er button five times (see Figure8). Walt
approximately two secondsbetween each
push.
IMPORTANT:When atartlng • warm engine,
do not use the primer button.
HOW TO USE
THE CLUTCH LEVER
1. Startthe engine.
2. Toengage the cuttingblade,move the
clutch lever forward (see Figure9).
3.
Select the edging depth you need. There
are five selections down to approximate-
ly 2-3/4 inches deep.
NOTE: For deep edging, first cut at shallow
depths. Then, cot at greater depths until
the desired depth
is obtained.
ClutchLevsr_
F-001106M
11
Advertisement
