Troubleshooting; Accessories - Craftsman 320.27669 Operator's Manual

PROBLEM
The router does not
work
The surface of the
workpiece is not
smooth after cutting
Bit can not be
installed
CAUSE
Plug is not plugged into
the power source.
Switch is in "OFF"
position.
The carbon brushes have
worn out completely.
The bit is dull.
Routing at an
inappropriate bit speed
Bit size is inappropriate
for the collet/nut
SOLUTION
Plug the cord into the
power source.
Pull the switch to "ON"
position.
Remove the carbon brush
caps, and replace the old
brushes with new ones.
Change to a sharp bit.
Select an appropriate bit
speed.
Use only 1/4 in. diameter
bits with the 1/4 in. collet;
use only 1/2 in. diameter
bits with the 1/2 in. collet.
WARNING: The use of attachments or accessories that are not
recommended for this tool might be dangerous and could result in serious injury.
Sears and other Craftsman outlets offer a large selection of Craftsman router
accessories designed for specific routing applications.
There is a large selection of Craftsman Router Cutting bits available in High-
Speed Steel or Carbide Tipped High-Speed Steel for all your routing needs.
In addition to a wide variety of router bits, Sears also offers accessories such
as: Router tables, various template sets, universal router fence with lock knobs
(64181), 11 pc. bushing set (64180) and clear sub-base sets; 6pc. fixed base
(64182) 6 pc. plunge base (64183).
,_ WARNING: Only use router tables with proper guarding for the cutting bit
and with "on-board" switch controlled receptacles. Failure to use router tables
with appropriate safety features could result in serious personal injury.
27669 ManuaLRevised_11 0215 Page 34