Advertisement
TO ATTACH
BATTERY
PACK TO DRILL
Gee Figure 6.
Note: Battery pack is shipped in a low charge condition.
Therefore, it must be charged prior to use. Refer to page 12,
"CHARGING BATTERY PACK" for charging instructions.
•
Lock the switch trigger by placing the direction of
rotation selector in center position. Gee Figure ff.
•
Align raised ribs on battery pack with grooves on
bottom of drill, then attach battery pack to drill as
shown in Figure 6.
•
Make sure latch on battery pack snaps into place and
battery pack is secured to drill before beginning
operation.
TO REMOVE
BATTERY
PACK
FROM DRILL
Gee FigureZ
•
Lock the switch trigger by placing the direction of
rotation selector in center position. Gee Figure if.
•
Depress latch located on front of battery pack (1) to
release battery pack.
•
Pull forward on battery pack (2) to remove from drill.
DEPRESSLATCHTO
RELEASEBATTERYPACK
LATCH
RAISEDRIBS
PULL
FORWARD
TO REMOVE
GROOVES
BATTERYPACK
Fig. 7
BATTERYPACK
Fig. 6
_,
CAUTION:
When attaching battery pack to your
drill, be sure raised ribs and grooves align properly
and latch snaps into place properly. Improper
assembly can cause damage to drill and battery
pack.
11
Advertisement
