Assembly; Unpackgenerator; Shipment Contents; Install Wheel Kit - Briggs & Stratton Generator Operator's Manual

Assembly
Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended oil
and fuel.
If you haveany problems with the assembly of your generator,
pleasecall the generator helpline at 1-888-743-4115. If calling
for assistance, pleasehavethe model, revision, and serial
number from the identification label available.See Generator
Controls and Featuresfor identification label location.
UnpackGenerator
1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
Shipment Contents
The generatoris suppliedwith:
• Engine oil bottle
• Operator's manual
• Wheel kit
Install Wheel Kit
NOTICE Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 13 mm and 18 mm wrench
• Socket wrench with 10 mm and 18 mm sockets
Install the wheel kit as follows:
1. Tip generator so that engine side is down.
2. Slide axle stud (A) through mounting bracket with
threaded end facing out.
3. Insert retaining pin (B) through hole on axle stud.
4. Slide a wheel (C) over axle stud.
NOTICE Be sure to install wheel with raised hub inboard.
5. Attach wheel to axle stud with a washer (D), lock
washer (E) and nut (F). Tighten with a 18 mm socket
wrench and 18 mm wrench.
6. Place hub cap (G) into center of wheel and push until it
snaps into place.
7. Repeat steps 2 through 6 to secure second wheel.
8. Line up holes in support leg (H) with holes in generator
frame.
,
10.
Attach support leg using 4 capscrews (J) and 4 hex
nuts (K). Tighten with a 10 mm socket wrench and
13 mm wrench.
Return generator to normal operating position (resting
on wheels).