Assembly - Bosch 5412L Operating Instructions Manual

Assembly
Tighten the cover plate screw.
Loose cover plate screw may inter-
fere with and hang-up lower blade guard. Never use
saw without cover plate securely in place. Lower
guard will not function properly.
9. Be sure the arbor lock is released so the blade
turns freely.
After installing a new blade,
make sure the blade does not
interfere with the table insert at the 0 ° and 45 °
bevel positions. Lower the blade into the table slot
and check for any contact with the base or turn table
structure. If blade contacts base or table, seek autho-
rized service.
10. Place multi purpose tool in rubber grommet in right
rear of tool.
Assembling
Dust Elbow And Dust Bag
1. With the miter arm locked in the down position,
push the dust elbow onto the dust port. Push the
dust bag onto the elbow and rotate both to desired
position. (Figure 4).
Dust
Port
Dust Bag Dust Elbow
Figure 4. Dust Elbow and Dust Bag
2. Position dust chute/bag so that it does not interfere
with the tool during the cutting operation for all
miter/bevel settings. Make sure dust bag does not
interfere with the slide rails during slide cutting.
3. The dust bag requires emptying when full of
sawdust. Empty it frequently and after completion
of sawing. Carefully remove dust bag from dust
elbow. Empty dust bag in proper trash
bin by unzipping the bag. Be extremely careful of
dust disposed, materials in fine particle form may
be explosive. Do not throw sawdust on an open
fire. Spontaneous combustion, may in time,
result from mixture of oil or water with dust
particles.
Note: The dust port also accepts a standard 1-1/4"
vacuum tube for dust collection.
When sawing chemically pressure
treated lumber, paint that may be
lead based, or any other materials that may contain
carcinogens, use special precautions. A suitable res-
pirator must be worn by all personnel entering the
work area. Work area should be sealed by plastic
sheeting and persons not protected should be kept
out until work area is thoroughly cleaned.
12.