Adjustments; Checking 0 ° Bevel Adjustment; Adjusting Bevel Lock Lever Tension; Instructions - Bosch 5412L Operating Instructions Manual

Adjustments
Disconnect plug from power source
before performing any assembly,
adjustment or repair to avoid possible injury.
NOTE: Your miter saw was completely adjusted at
the factory. However, during shipment, slight mis-
alignment may have occurred. Check the following
settings and adjust if necessary prior to using this
miter saw.
Checking 0° Bevel
Adjustment
1. Push head assembly down and push head assem-
bly lock pin to hold down head assembly.
2. Slide head assembly completely to the back and
tighten the rail lock knob.
3. Rotate table to 0 ° miter position
4. Pull up bevel lock lever to loosen.
5. Check position of bevel range selector knob, it
should be at the 00-45 ° position.
6. Tilt the saw assembly to the left counterclockwise.
Then rotate saw assembly to the right (clockwise).
Until you feel the stop in the vertical position - This
is where the saw is currently set for the 0° bevel
cut.
Lower the blade and engage the lock pin. Use a
combination square to check blade squareness to
the table. Place the square on the table and press
it against the blade. If the blade does not contact
the full length of the square, (figure 5), follow the
alignment procedure.
Table
Combination Bevel Lock
Square Lever
Figure 5. Blade Square to Table
Calibrating Blade at 0 degrees
(90 ° to the table)
Lift bevel lock lever to release bevel lock.
,
2. Loosen bolt heads "A" and "B" with 10 mm open-
end wrench at least one full turn (Figure 6).
3. Place 4 mm Allen wrench bit onto multi purpose
tool and into setscrew "D" (Figure 6).
4. Loosen setscrew "D" with 4 mm Allen wrench - at
least 3 full turns.
C
A
B
D E
Figure 6. Calibrating Blade at 0 degrees
(90 to the table)
5. Place combination square on table and against
fence. (See figure 5)
6. While rotating bolt head "C", watch the saw blade
tilt until it is aligned with the combination square.
When aligned, remove the Allen wrench.
7. Tighten setscrew "D".
8. Tighten 10 mm bolt heads "A" & "B"
9. Check and adjust bevel pointers to 0 degrees on
each side of bevel scale.
10. Push down bevel lock lever before cutting.
Adjusting Bevel Lock Lever Tension
1. Lift bevel lock lever to release bevel lock.
2. Place 17-mm open-end flat wrench on bolt head
"E" (Figure 6).
3. Turn nut "E" clockwise 1/8 turn to tighten bevel
lock tension or turn counter-clockwise to 1/8 turn
to loosen bevel lock tension.
4. Push down bevel lock lever.
5. Verify that bevel lock tension holds the bevel posi-
tion secure and also allows bevel lock lever to lock
down to the point that a solid stop is felt.
6. If necessary, repeat steps 1 - 5 to adjust the
tension.
13.