Special Cuts - Bosch 5412L Operating Instructions Manual

Saw Operations
Special Cuts
Cutting bowed material and round material are only
two examples of special cuts.
Cutting Bowed Material
If workpiece is bowed or warped,
clamp it with the outside bowed face
toward the fence. Always make certain that there is
no gap between the workpiece, fence and table
along the line of cut. Bent or warped workpieces can
twist or rock and may cause binding on the spinning
saw blade while cutting (Figure 37).
Quick
Action
Clamp
Fence
i o
i
Bowed
Material
No Gap at
this Point
Figure 37. Bowed Material
Cutting Round or Irregularly
Shaped Material
For round material such as dowel
rods or tubing, always use a clamp
or a fixture designed to clamp the workpiece firmly
against the fence and table. Rods have a tendency to
roll while being cut, causing the blade to "bite" and
pull the work with your hand into the blade
(Figure 38).
Quick
Action
Clamp
Fence
Round
Material
Figure 38. Round Material
31.