Logo Command - Xerox DocuPrint 96MX Forms Creation Manual

FORMS DESCRIPTION LANGUAGE

LOGO command

3-38
Placing logos A complex figure called a logo, up to two square inches in size, can
be digitized to order by the Xerox Font Center or Xerox Limited. This
logo is a special font of one or more characters, which carries with it
the relative position of the characters to make up the logo. Thus,
while a logo may be made up of many characters, it is positioned as
a single unit. For additional flexibility, a signature may be digitized
and stored on the system as a logo.
Note: Be sure that font memory capacity is not exceeded. Logos
larger than two square inches may be used if they are the result of
using smaller components of the logo to gain the desired effect.
Placement is accomplished with the following command:
LOGO id AT y [unit] x [unit];
The logo identifier (1 to 6 characters) is id.
Example:
LOGO EAGLE AT 10, 12;
LOGO ORIGIN: - - - >
LOGO
EAGLE
AT 10, 12 The keyword AT and the coordinates (y,x) indicate
Sample FSL The LOGO command is typically inserted towards the end of the FSL
as illustrated in figure 3-19.
Figure 3-19. Placing a logo
HORIZONTAL TEXT USING FONT 2 IN CENTER CENTER
BOX 6,1 'DATE';
COMMENT *** PLACE LOGO ***;
LOGO RABBIT AT 1,26;
END;
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS FORMS CREATION GUIDE
Keyword LOGO
The name of the logo, which is a one to six
alphanumeric character label, is assigned to the logo
when it is digitized by the Xerox Font Center or Xerox
Limited.
where the top left corner of the logo is to be placed.