Installing The Document Submission Client Software - Xerox DocuPrint Network Printer Series Client Manual

SETTING UP WORKSTATIONS

Installing the Document Submission Client Software

Verifying your installation
2-8
To install a new version of Xerox Document Submission Client
Software:
1. Move the existing Xerox Document Submission Client icon from
your desktop to the trash.
2. Select Empty Trash from the Special menu.
3. Make a backup copy of the software diskette. See your
Macintosh reference manual for this procedure.
4. Create a new folder on the hard disk entitled "DP Mac Client."
5. Insert the Client Software diskette in the diskette drive.
6. Open the diskette icon and drag the DocuPrint icon into the new
DP Mac Client folder.
7. Drag the Golden Print Job PostScript Sample Test file
XRXGPJ1.ps into the folder.
8. Drag the PPD File for your DocuPrint NPS printer model to the
System Folder: Extensions:Printer Descriptions.
If there is no folder with this name, create one.
The files are named XDP####.PPD, where #### is your
DocuPrint model number; for example, XDP 4635.PPD.
9. Eject the diskette.
Assuming your system is directly connected to the network, perform
the following steps to verify that your installation was successful:
1. Open the Mac Control Panel and select the Network icon.
2. Select the EtherTalk Phase icon for the type of AppleTalk
connection on the network, and then close the Mac Control
Panel.
3. If your network is configured to include AppleTalk print zones,
open the Chooser and select the AppleTalk Zone where
DocuPrint is installed.
Caution: To avoid conflict with UNIX regular expressions,
ensure that "&" is not in the zone name. If the "&" must be used
in the zone name, have your Network Administrator enter "\\&"
instead.
4. Select the LaserWriter icon.
The AppleTalk printer name for the DocuPRint printer appears
in the window.
5. Select the AppleTalk printer name and close the Chooser.
6. In the DP Mac Client folder, double-click the DocuPrint icon to
start the client software.
7. Select Choose Printer Type and select your printer model.
8. In the printer queue, select Use Chooser Setting.
GUIDE TO SUBMITTING JOBS FROM THE CLIENT