Helpful Hints; Troubleshooting; Accessories - Black & Decker BD200MT Instruction Manual

•Always e nsure t heworkpiece isfirmly held orclamped toprevent movement. Any
movement ofthematerial may affect thequality o fthecutting orsanding f inish.
• Donotstart s anding w ithout having t hesandpaper attached tosanding p laten.
• Use coarse g ritpaper tosand rough s urfaces, medium gritforsmooth s urfaces and
finegritforthefinishing surfaces. If necessary, first m ake a test r unonscrap material.
• Donotallow thesandpaper towear a way, itwill d amage t hesanding pad.
• Excessive force wilt r educe t heworking e fficiency andcause motor overload.
Replacing theaccessory regularly willmaintain optimum w orking e fficiency.
• Ifthetoot o verheats, especially when used atlowspeed, setthespeed t omaximum
andrunitwithnoload for2-3minutes tocool t hemotor. Avoid prolonged usage a tvery
lowspeeds. Always k eep theblade sharp.
Problem Possible Cause Possible Solution
• Unit wilt not start.
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
• Plug toot into a working
outlet.
• Replace circuit fuse. (If
the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have
it serviced at a Black &
Decker service center or
authorized servicer.)
• Reset circuit breaker.
(If the product
repeatedly causes the
circuit breaker to trip,
discontinue use
immediately and have
it serviced at a Black &
Decker service center or
authorized servicer.)
• Have cord or switch
replaced at a Black &
Decker service center or
authorized servicer.)
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1=800=544=6986.
Recommended accessories for use with your toot are listed on page 10 and 11 and are
available from your local dealer or authorized service center. In addition to Black &
®
Decker accessories, your BD200MT Tool Free Release system wilt also accept Porter
® ®
Cable and Stanley FatMax oscillating toot accessories. If you need assistance
regarding accessories, please call: 1=800=544=6986.
z_WARNING." The use of any accessory not recommended for use with this tool could
be hazardous.