Black & Decker BDCJS18N Original Manual
Black & Decker BDCJS18N Original Manual

Black & Decker BDCJS18N Original Manual

Hide thumbs Also See for BDCJS18N:




Table of Contents

Subscribe to Our Youtube Channel

Summary of Contents for Black & Decker BDCJS18N

  • Page 1 BDCJS18N BDCJS18
  • Page 2 BDCJS18...
  • Page 4: Intended Use

    If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) Your BLACK+DECKER BDCJS18N and BDCJS18 jigsaw protected supply. Use of an RCD reduces the risk of has been designed for sawing wood, plastics and sheet metal.
  • Page 5 (Original instructions) ENGLISH Hold power tool by insulated gripping surfaces, when d. Store idle power tools out of the reach of children and performing an operation where the cutting accessory do not allow persons unfamiliar with the power tool or may contact hidden wiring.
  • Page 6 ENGLISH (Original instructions) Residual risks Do not store in locations where the temperature may exceed 40 °C. Additional residual risks may arise when using the tool which Charge only at ambient temperatures between 10 °C and may not be included in the enclosed safety warnings. These 40 °C.
  • Page 7: Variable Speed Control

    (Original instructions) ENGLISH Assembly Leaving the battery in the charger Warning! The charger and battery pack can be left connected with the Before assembly, remove the battery from the tool LED glowing indefinitely. The charger will keep the battery and make sure that the saw blade has stopped. Used saw pack fresh and fully charged.
  • Page 8: Protecting The Environment

    ENGLISH (Original instructions) Note: The shoe can be beveled to the left or to the right and has detents at 22.5° and 45°. saw blade for ferrous metals and a coarser saw blade for non-ferrous metals. When cutting thin sheet metal, clamp a piece of scrap This jig saw is equipped with three cutting actions, two orbital wood to the back surface of the workpiece and cut through and one straight.
  • Page 9: Technical Data

    Run the battery down completely, then remove it from the tool. NiCd, NiMH and Li-Ion batteries are recyclable. Take them to any authorised repair agent or a local recycling station. Technical Data BDCJS18N Voltage 0-2500 No-load speed Stroke length Max depth of cut:...
  • Page 12 Australia & New Zealand Stanley Black & Decker Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) 90626716 07/2015...

This manual is also suitable for:


Table of Contents