Installing/Removing Sanding Sheets - Black & Decker BD200MT Instruction Manual

• Slide the accessory between the shaft
and the accessory holder making sure the
accessory engages all eight pins on the
holder and is flush with the shaft (figure 2.
• Release the accessory clamp lever.
O
• Some accessories, such as scrapers
and blades can be mounted at an angle if
required as shown in figure 3.
Installing/Removing Sanding
Sheets - Figure 4
A triangle shaped base, or platen, uses a
hook and loop adhesion system to attach
the sanding sheets.
• Attach the sanding platen as described
under "Installing/Removing Accessories".
• Align the edges on the sanding sheet,
with the edge of the sanding platen and
press the sanding sheet onto the platen.
• Firmly press the base with the sanding
sheet attached against a flat surface and
briefly switch the toot on. This provides
for good adhesion between the platen
and the sanding sheet and also helps to
prevent premature wear.
• When the tip of the sanding sheet
becomes worn, detach the sheet from the
platen, rotate and reapply.
O