Components; Intended Use; Assembly; Installing/Removing Accessories - Black & Decker BD200MT Instruction Manual

A.)On/Off switch
B.)Variable speed d ial
C.)Power cord
D.)Tool-Free Release
Detail Sanding
Sanding in extremely tight areas otherwise difficult to reach and require hand sanding.
Select a high oscillating frequency. Sand with continuous motion and light pressure.
Applying excessive pressure does not increase material removal but will prematurely
wear sanding sheets.
Flush Cutting
Remove excess wood from door jamb, window silt and/or toe kick. Removing excess
copper or PVC pipe.
Removal Work
Carpets & backing, old tile adhesives, caulking on masonry, wood and other surfaces.
Removal of Excess Materials
Tile grout, plaster, mortar splatters, concrete on tiles, sills.
Preparation of Surfaces
New floors and tiles.
zhWARNING:
Disconnect the plug from the power source before making any
assembly, adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Z_WARNING: Risk of lacerations or burns. Do not touch workpiece or blade
immediately after operating the toot. They can become very hot. Handle carefully.
Always allow workpiece and accessories to cool before handling.
Installing/Removing
Accessories
The BD200MT features an exclusive tool-
free accessory changing system. This
allows for faster accessory changes
without the need for wrenches or hex
keys like other oscillating toot systems.
• Grasp the tool and squeeze the
accessory clamping lever as shown in
figure 1.
• Clean any residual debris from the tool
shaft and the accessory holder.
\