Setting The Digital Input (Digital In) Terminals; Selecting The Analog Or Digital Input Mode; Basic Settings - JVC RX-5022VSL Instructions Manual

Basic Settings
/
a
mo
O
,.Q
a
mo
o
€1
a
mo
mo
=l
t,.¢l
When you use the digital input terminals, register what components
are connected to which terminals (DIGITAL 1/2) so that the correct
source name will appear when you select the digital source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step ! again.
I Press SETTING repeatedly until SE.,NG
"DIGITAL IN" appears
on the display. _,),Nc,_
The display changes to show the current setting.
DIGITAL 2 terminal setting
]
DIGITAL 1 terminal setting
* "1DVD 2CD" is the initial setting. If you have already
changed the setting, another combination will be shown.
2 Press CONTROL UP A/DOWN • to OONT,OL
DOWN UP
• A
select the appropriate digital terminal i I _
setting.
• Each time you press the button, the display
changes to show the following:
IDVD2CD _ IDVD2TV_ IDVD2CDR
ICD 2DVD_ ICD 2TV_ ICD 2CDR
1TV 2DVD_ 1TV 2CD_ 1TV 2CDR
1CDR2DVD_ 1CDR2CD_ 1CDR2TV
(back to the beginning)
Note:
When shipped from the factory, the DIGITAL IN terminals can be used
as the digital input for the following components.
- DIGITAL 1 (coaxial): For DVD player
- DIGITAL 2 (optical): For CD player
When you have connected digital source components using both the
analog connection (see page 6) and the digital connection (see page
7) methods, you need to select the input mode correctly.
Press one of the source selecting buttonsmDVD,
TV SOUND, CD, or TAPE/CDR*mfor which you
want to change the input mode.
DVD VCF/ "PC SOUND TAPE/CDR CD DVD
' I,!_ TV SOUND ',/C
On the front panel From the remote control
2
Note:
* Among the sources listed above, you can select the digital input
only for the sources which you have selected the digital input
terminals for. (See "Setting the Digital Input (DIGITAL IN)
Terminals.")
Select digital input mode.
Onthe front panel:
Press INPUT DIGITAL.
"DIGITAL AUTO" appears on the display
and the indicator for the detected signals also
lights up.
To change the input mode back to analog
input, press INPUT ANALOG.
"ANALOG" appears on the display for a
while.
INPUT DIGITAL
INPUT ANALOG
From the remote control:
Press ANALOG/DIGITAL. _N_OG
/DIGITAL
• Each time you press the button, the input mode
alternates between the analog input ("ANALOG")
and the digital input ("DIGITAL AUTO").
TO BE CONTINUED TO THE NEXT PAGE
11