Using The Midnight Mode-Midnight Mode; Setting The Digital Input (Digital In) Terminals; Digital In 1/2/3; Setting The Auto Function Mode -Auto Mode - JVC RX-D301S Instructions Manual

Using the Midnight mode
—MIDNIGHT MODE
You can enjoy a powerful sound at night using the Midnight mode.
When the Midnight mode is activated, the MIDNIGHT indicator
lights up on the display.
< >
MIDNIGHT OFF Select when you want to enjoy surround
with its full dynamic range. (No effect
applied.)
< >
MIDNIGHT 1 Select when you want to reduce the
dynamic range a little.
< >
MIDNIGHT 2 Select when you want to apply the
compression effect fully (useful at night).
<
Initial setting: MIDNIGHT OFF
From the remote control:
Press MIDNIGHT repeatedly to select either one of the
above.
1
4
7
10
NOTE
When "DVD MULTI" is selected as the source, this function is not
available.
Setting the digital input (DIGITAL IN)
terminals—DIGITAL IN 1/2/3
When you use the digital input terminals, register what
components are connected to which terminals—DIGITAL IN 1/2/3
(see page 11) so that the correct source name will appear when
you select the digital source.
Select one of the following components for each terminal:
DVR/DVD For the DVD player (or DVD recorder).
VIDEO For the component connected to the VIDEO IN jacks
on the rear of the receiver.
VCR For the VCR.
TV For the TV.
Initial setting: DVR/DVD (for "DIGITAL IN 1")
VIDEO (for "DIGITAL IN 2")
TV (for "DIGITAL IN 3")
22
>
2 3
5 6
8 9
0 10
NOTES
• You cannot assign the same component for different terminals.
The priority order for assignment is as follows:
"DIGITAL IN 1" > "DIGITAL IN 2" > "DIGITAL IN 3."
Ex.: When "DIGITAL IN 1" is set to "DVR/DVD."
DVR/DVD
DIGITAL IN 1
For "DIGITAL IN 2," "VIDEO," "VCR," and "TV" are
selectable.
• In this case, "VCR" is selected.
DVR/DVD VIDEO
DIGITAL IN 2
For "DIGITAL IN 3," "VIDEO" and "TV" are selectable.
DVR/DVD
DIGITAL IN 3
: Selectable
• Setting "DIGITAL IN 1" affects "DIGITAL IN 2" and "DIGITAL IN
3" settings. When you have changed "DIGITAL IN 1," confirm the
components assigned to "DIGITAL IN 2" and "DIGITAL IN 3."
Setting the Auto Function mode
—AUTO MODE
The source will be selected automatically simply by turning on a
video component.
• This function takes effect for the video components connected
to the receiver using the SCART cable—DVR/DVD and VCR.
Auto Function mode works as follows:
• When a video component is turned on, the receiver selects the
video component as the source (and the TV input is changed
automatically).
• When a video component currently selected as the source is
turned off, the receiver changes the source to the video source
previously selected—DVR/DVD, VCR, or VIDEO.
< >
MODE AUTO1 Auto Function mode works when the
receiver is on.
< >
MODE AUTO2 Auto Function mode works whether or not
the receiver is on. When the receiver is
off, turning on a video component turns
on the receiver, then the video component
is selected as the source.
< >
MODE MANUAL You need to select the source manually.
<
Initial setting: MODE MANUAL
< >
When "MODE AUTO1 " or "MODE
AUTO MODE indicator lights up on the display.
NOTE
When selecting VCR as the source, only turning on the VCR may
< >
not activate "MODE AUTO1
start playback to activate Auto Function mode.
VIDEO VCR TV
VCR TV
VIDEO VCR TV
: Not selectable
>
< >
AUTO2 " is selected, the
." If this happens, you may need to