Table of Contents
Advertisement
Troubleshooting
Use this chart to help you solve daily operational
problems.
If there is any problems
you cannot solve, contact
your JVC's
service center.
The power does not come on.
The power cord is not plugged
in.
Plug the power cord into an AC outlet.
The SPEAKERS
ON/OFF button is not
set correctly.
Press SPEAKERS
ON/OFF button correctly.
Muting is activated.
Press MUTINGto
cancel themute.
Connections
are incorrect.
Check connections.
For analog connections,
see page 6.
For digital connections,
see page 7.
The balance
is set to one extreme.
Adjust the balance properly (see page 15).
The station is too far away.
Select a new station.
Antennas
are not connected
properly.
Check connections.
"OVERLOAD"
stalts flashing
on the
display.
Speakers
are overloaded
because of high
volume.
1. Press STANDBY/ON
O/I on the front
panel to turn off the receiver.
2. Stop the playback
source.
3. Turn on the receiver
again, and adjust the
volume.
"DSP MICON
NG" starts flashing
on the
display.
The built-in
microcomputer
is not
functioning
correctly.
Press STANDBY/ON
O/I on the front panel to
turn off the receiver.
After unplugging
the
power cord, consult your dealer.
Remote control does not work.
There is an obstruction
in front of the
remote sensor on the receiver.
Remove the obstruction.
Remote control does not work as you
intend.
The remote control is not ready for your
intended operation.
Press SOUND or a source selecting button
first, then press the buttons you want to use.
(See pages 25 to 27).
3O
Hide quick links:
Advertisement
Table of Contents
