Confirm Your Network Environment; Connected To A Computer With A Wlan Access Point/Router In The Network (Infrastructure Mode) - Brother MFC-9130CW Network User's Manual

Configuring your machine for a wireless network (For DCP-9020CDW, MFC-9130CW, MFC-9330CDW and MFC-9340CDW)

Confirm your network environment

Connected to a computer with a WLAN access point/router in the network
(Infrastructure mode)
1 WLAN access point/Router
1
If your computer supports Intel
point.
2 Wireless network machine (your machine)
3 Wireless capable computer connected to the WLAN access point/router
4 Wired computer which is not wireless capable connected to the WLAN access point/router with a
network cable
Configuration method
The following instructions will offer four methods for configuring your Brother machine in a wireless network
environment. Choose the method you prefer for your environment.

Wireless configuration temporarily using a USB cable (Recommended)
See Wireless configuration temporarily using a USB cable (Recommended) on page 13.

Wireless configuration using the Setup Wizard from the control panel
See Configuration using the machine's control panel Setup Wizard on page 18.

One push wireless configuration using WPS (Wi-Fi Protected Setup™) or AOSS™
See One push configuration using WPS (Wi-Fi Protected Setup) or AOSS™ on page 27.

PIN Method wireless configuration using WPS
See Configuration using the PIN Method of WPS (Wi-Fi Protected Setup) on page 29.
4
1
®
MWT (My WiFi Technology), you can use your computer as a WPS (Wi-Fi Protected Setup) supported access
1
3
2
3
3
3
3
11