Brother MFC-9130CW Network User's Manual page 36

Configuring your machine for a wireless network (For DCP-9020CDW, MFC-9130CW, MFC-9330CDW and MFC-9340CDW)
a
Press .
b
Press Network.
c
Press WLAN.
d
Swipe up or down, or press a or b to display WPS w/PIN Code.
Press WPS w/PIN Code.
e
When Enable WLAN? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
f
The Touchscreen will show an 8 digit PIN and the machine starts searching for an access point.
g
Using a computer that is on the network, type "vaccess point's IP address/" into your browser.
(Where "access point's IP address" is the IP address of the device that is used as the Registrar
the WPS setting page and input the PIN which the Touchscreen shows in f to the Registrar. Follow the
on-screen instructions.
1
The Registrar is normally the WLAN access point / router.
NOTE
The setting page is different, depending on the brand of access point / router. See the instruction manual
supplied with your access point / router.
3
1
.) Go to
30